Recall Date:
SEP 01, 1992
Model Affected:
1990 PONTIAC 6000
Summary:
THE POWER SEAT OR RECLINER WIRING HARNESS CAN BE PINCHED OR CAN CHAFE ON THE SEAT FRAME OR SPRING SUPPORT ROD, WEARING THROUGH THE WIRE INSULATION AND CAUSING AN ELECTRICAL SHORT.
Consequence:
THE HIGH CURRENT CAUSED BY THE ELECTRICAL SHORT WELDS THECIRCUIT BREAKER ELEMENTS TOGETHER IN THE CLOSED POSITION, LEAVING THE CIRCUITUNPROTECTED AND GENERATING SUFFICIENT HEAT TO BURN THE WIRE INSULATION ANDIGNITE THE SEAT CUSHION MATERIAL.
Remedy:
REPAIR ANY ABRADED WIRING AND REROUTE THE WIRING HARNESS USING A WIRING HARNESS CLIP.
Units Affected:
319181
Notes:
GENERAL MOTORS CORP.
Recall Date:
SEP 15, 1995
Model Affected:
1990 PONTIAC 6000
Summary:
THESE VEHICLES WERE ASSEMBLED WITH REAR OUTBOARD SAFETY BELT ANCHORAGES THAT MAY NOT WITHSTAND THE REQUIRED LOAD. THIS DOES NOT COMPLY WITH FMVSS NO.210, "SEAT BELT ASSEMBLY ANCHORAGES."
Consequence:
CONSEQUENCE OF NON-COMPLIANCE: IN A COLLISON, STRESS CAN CAUSE THE ATTACHMENT METAL TO TEAR AND ALLOW THE ANCHORAGE TO SEPARATE FROM THE BODY OF THE VEHICLE. THE SAFETY BELT MAY NOT PROTECT AN OCCUPANT IN THE EVENT OF A VEHICLE CRASH.
Remedy:
DEALERS WILL REPLACE THE EXISTING ANCHOR BOLTS WITH A NEW SHOULDER BOLT AND THREAD LOCKING ADHESIVE. ADDITIONALLY, NOISE CONTROL PATCHES WILL BE APPLIED AT EACH ANCHORAGE.
Units Affected:
2216325
Notes:
GENERAL MOTORS CORP.