BMW X5 Recalls
| Recall Date: |
JUL 24, 2002 |
| Component: |
SERVICE BRAKES, HYDRAULIC:PEDALS AND LINKAGES |
| Model Affected: |
X5 |
| Units Affected: |
34860
Recall Details
|
Recall Date:
JUL 24, 2002
Model Affected:
2000 BMW X5
Summary:
ON CERTAIN PASSENGER VEHICLES, DUE TO A MANUFACTURING PROBLEM, THE BRAKE PEDAL ARM PIVOT SHAFT COULD LOOSEN FROM ITS SUPPORT BRACKET.
Consequence:
EVENTUALLY, THE BRAKE PEDAL ARM COULD DETACH FROM THE BRACKET, RENDERING THE SERVICE BRAKING SYSTEM INEFFECTIVE, INCREASING THE RISK OF A CRASH.
Remedy:
DEALERS WILL CHECK THE BRAKE PEDAL ARM PIVOT SHAFT FOR PROPER SEATING IN ITS SUPPORT BRACKET. IN ADDITION, A PIN WILL BE INSTALLED TO SECURE THE SHAFT TO THE BRACKET. OWNER NOTIFICATION BEGAN AUGUST 14, 2002. OWNERS WHO TAKE THEIR VEHICLES TO AN AUTHORIZED DEALER ON AN AGREED UPON SERVICE DATE AND DO NOT RECEIVE THE FREE REMEDY WITHIN A REASONABLE TIME SHOULD CONTACT BMW AT 1-800-332-4269.
Units Affected:
34860
Notes:
BAYERISCHE MOTOREN WERKE
| Recall Date: |
JUN 14, 2001 |
| Component: |
SERVICE BRAKES, HYDRAULIC:FOUNDATION COMPONENTS:HOSES, LINES/PIPING, AND FITTINGS |
| Model Affected: |
X5 |
| Units Affected: |
13721
Recall Details
|
Recall Date:
JUN 14, 2001
Model Affected:
2000 BMW X5
Summary:
VEHICLE DESCRIPTION: 4.4I SPORT UTILITY VEHICLES. THERE IS A PLASTIC CARRIER TO WHICH THE OIL FILTER HOUSING IS ATTACHED. OIL SUPPLY AND RETURN LINES ARE ATTACHED TO THE FILTER HOUSING. OVER TIME, THIS CARRIER COULD SAG SLIGHTLY. IF THIS HAPPENS, ONE OF THE OIL LINES, WHICH ARE ARMORED WITH STEEL MESH, COULD COME INTO CONTACT AND CHAFE A STEEL BRAKE LINE LOCATED IMMEDIATELY UNDERNEATH.
Consequence:
CONTINUED CHAFFING CAN CAUSE THE ANTICORROSION COATING OF THIS BRAKE LINE TO FAIL, ALLOWING THE BRAKE LINE TO RUST THROUGH AND LEADING TO LOSS OF BRAKE FLUID, FAILURE OF THE REAR BRAKE CIRCUIT, AND EXTENDED STOPPING DISTANCES, AND A POSSIBLE CRASH.
Remedy:
DEALERS WILL INSTALL A RUBBER SPACER BELOW THE PLASTIC CARRIER TO PREVENT SAGGING AND SUBSEQUENT CONTACT BETWEEN THE OIL AND BRAKE LINES. BRAKE LINES WHOSE ANTICORROSION LAYER IS FOUND TO BE DAMAGED AS A RESULT OF CONTACT WITH THE OIL LINE WILL BE REPLACED. OWNER NOTIFICATION BEGAN AUGUST 14, 2001. OWNERS WHO TAKE THEIR VEHICLES TO AN AUTHORIZED DEALER ON AN AGREED UPON SERVICE DATE AND DO NOT RECEIVE THE FREE REMEDY WITHIN A REASONABLE TIME SHOULD CONTACT BMW AT 1-800-831-1117.
Units Affected:
13721
Notes:
BAYERISCHE MOTOREN WERKE
| Recall Date: |
JAN 09, 2003 |
| Component: |
SERVICE BRAKES, HYDRAULIC:FOUNDATION COMPONENTS:HOSES, LINES/PIPING, AND FITTINGS |
| Model Affected: |
X5 |
| Units Affected: |
84000
Recall Details
|
Recall Date:
JAN 09, 2003
Model Affected:
2000 BMW X5
Summary:
ON CERTAIN SPORT UTILITY VEHICLES, IT MAY BE POSSIBLE FOR THE FRONT BRAKE LINE TO SLIP OUT OF THE RETAINING BRACKET LOCATED AT THE FRONT STRUT. THE BRAKE HOSE THAT IS ATTACHED TO THE BRAKE LINE COULD COME IN CONTACT WITH THE TIRE AND BE SUBJECTED TO WEAR AND ABRASION.
Consequence:
THIS COULD INITIALLY CAUSE SOME BRAKE FLUID LEAKAGE, AND EVENTUALLY LEAD TO A SUBSTANTIAL LOSS OF BRAKE FLUID. THERE COULD BE A NOTICEABLE REDUCTION IN BRAKE PERFORMANCE IF A LOSS OF FRONT BRAKE PERFORMANCE OCCURS.
Remedy:
DEALERS WILL INSTALL AN ADDITIONAL RETAINING CLIP TO FURTHER SECURE THE BRAKE LINE TO THE FRONT STRUT. ADDITIONALLY, IF INSPECTION OF ANY BRAKE HOSE INDICATES THAT IT HAS EXPERIENCED DAMAGE, THE HOSE WILL BE REPLACED. OWNER NOTIFICATION BEGAN FEBRUARY 14, 2003. OWNERS WHO TAKE THEIR VEHICLES TO AN AUTHORIZED DEALER ON AN AGREED UPON SERVICE DATE AND DO NOT RECEIVE THE FREE REMEDY WITHIN A REASONABLE TIME SHOULD CONTACT BMW AT 1-800-831-1117.
Units Affected:
84000
Notes:
BAYERISCHE MOTOREN WERKE
| Recall Date: |
JAN 18, 2000 |
| Component: |
STEERING:WHEEL AND HANDLE BAR |
| Model Affected: |
X5 |
| Units Affected: |
190
Recall Details
|
Recall Date:
JAN 18, 2000
Model Affected:
2000 BMW X5
Summary:
VEHICLE DESCRIPTION: SPORT UTILITY VEHICLES. THE LOWER STEERING SHAFT COUPLING INCLUDES A PLASTIC COLLAR WHICH FITS OVER THE LOWER STEERING RACK INPUT SHAFT. THIS COLLAR IS PUSHED DOWN ONTO THE STEERING RACK AND TIGHTENED DURING ASSEMBLY. ON SOME OF THE AFFECTED VEHICLES, THE COLLAR MAY NOT HAVE BEEN PUSHED DOWN FULLY ONTO THE RACK AT THE ASSEMBLY PLANT.
Consequence:
OPERATION OF THE VEHICLE, ESPECIALLY IN ROUGH ROAD CONDITIONS, CAN CAUSE THE CLEARANCE BETWEEN THE COLLAR AND THE STEERING RACK TO INCREASE TO THE POINT WHERE THE INPUT SHAFT CAN SEPARATE FROM THE RACK, RESULTING IN A LOSS OF STEERING CAPABILITY.
Remedy:
DEALERS WILL INSPECT THE STEERING RACK INPUT SHAFT COLLAR FOR PROPER POSITIONING, AND REPOSITION IS NECESSARY.
Units Affected:
190
Notes:
BAYERISCHE MOTOREN WERKE 00VX5SC01
| Recall Date: |
JUN 14, 2001 |
| Component: |
POWER TRAIN:AUTOMATIC TRANSMISSION:PARK/NEUTRAL START SWITCH |
| Model Affected: |
X5 |
| Units Affected: |
14300
Recall Details
|
Recall Date:
JUN 14, 2001
Model Affected:
2000 BMW X5
Summary:
VEHICLE DESCRIPTION: 4.4I SPORT UTILITY VEHICLES. OVER AN EXTENDED PERIOD OF TIME, ABRASION PARTICLES COULD DEPOSIT ON THE ELECTRICAL CONTACTS WITHIN THE SWITCH, CAUSING A DISRUPTION OF THE ELECTRIC CURRENT THROUGH THE CONTACTS. IF THE DISRUPTION OCCURS WHEN THE VEHICLE IS STATIONARY WITH THE TRANSMISSION IN THE NEUTRAL OR PARK POSITIONS, THE TRANSMISSION WILL SWITCH AUTOMATICALLY INTO THE EMERGENCY PROGRAM, WHICH IS DISPLAYED IN THE INSTRUMENT CLUSTER VIA A WARNING LAMP AND A MESSAGE, "TRANS. FAIL-SAFE PROG." IN THIS CASE, THE VEHICLE CAN BE DRIVEN IN LOWER GEARS ONLY WITH LIMITED ENGINE OUTPUT.
Consequence:
IF THIS PROBLEM OCCURS, THE ABILITY TO MAINTAIN SPEED IN TRAFFIC AND/OR ACCELERATE COULD BE GREATLY DIMINISHED, POSSIBLY LEADING TO A CRASH.
Remedy:
DEALERS WILL REPLACE THE TRANSMISSION GEAR POSITION INDICATOR SWITCH. OWNER NOTIFICATION BEGAN AUGUST 14, 2001. OWNERS WHO TAKE THEIR VEHICLES TO AN AUTHORIZED DEALER ON AN AGREED UPON SERVICE DATE AND DO NOT RECEIVE THE FREE REMEDY WITHIN A REASONABLE TIME SHOULD CONTACT BMW AT 1-800-831-1117.
Units Affected:
14300
Notes:
BAYERISCHE MOTOREN WERKE
|
Submodel Select
| |
|
|