The 2011.5 BMW 135i DCT raised a lot of questions—like can the same types of modifications create the same performance increases?
more
|
At a glance, designing and building a traction control system is easy: Monitor front and rear wheel speeds, and cut power if the rear wheel goes faster than the front. And from a safety standpoint — preventing a crash — a basic system is quite adequate.
more
|
How To Turn Off The EDC Warning Light After Fitting Coilovers.
more
|
Project M3 gets another makeover with a carbon trunk, front lip, roof wrap plus H&R coilovers.
more
|
Getting the most bang for your buck with the BMW N54 motor using water/methanol injection.
more
|
Project M3 Finally Gets Engine Software From GIAC, With Good Results.
more
|
This month we dyno test a carbon intake and titanium exhaust from GruppeM on our Project M3’s 4.0 V8.
more
|
This month we dyno test a carbon intake and titanium exhaust from GruppeM on our Project M3’s 4.0 V8
more
|
Another Look At Some Exciting Euro Projects Under Construction
more
|
Every time I get behind the wheel of a BMW equipped with a 3.0L turbocharged engine I spend a good amount of my time contemplating why BMW would handicap such a great car. Why restrict an engine with so much obvious potential?
more
|
More Modifications To Our E90 M3; This Time Its Lowering Springs And New Wheels.
more
|
We Continue To Modify Our E90 M3 With More Carbon Pieces From BMW Performance.
more
|
We Continue To Modify Our E90 M3 With Six-Piston Brembo Brakes.
more
|
Another Look At Some Exciting Euro Projects Under Construction
more
|
We Begin Modifying Our E90 M3 With Parts From BMW Performance And Turner Motorsport.
more
|
We install a VF Cold Air Intake, as well as GIAC Software to see how much power we can squeeze out of a E46 M3.
more
|
Paul Piola Advises What To Look For And Replace When Buying A '92-99 E36 BMW 325i Or 328i.
more
|
We Try New Headers, Brakes And More On Our BMW Project Car.
more
|
We left off in the E46 racecar project series with pro skateboarder Rune Glifberg's 2003 M3 receiving an six-point chrome-moly rollcage, fully fabricated and welded together by the metal artisans at Evosport in Huntington Beach, Calif.
more
|
Paul Piola Advises What To Look For When Buying An E30 BMW 325i.
more
|
Join us as we bid farewell to our completed project car, the BMW 135i.
more
|
Garrett Integrated Automotive Corp lends us a helping hand in the software department with their new flash system for our BMW 135i project car.
more
|
We provide a few updates on our project cars including the 135i, the gti, and project silverstone. Check out the suspension, wheel and tire, and software upgrades here.
more
|
Read part two of the 2003 BMW M3 project car series, and see how European Car builds this M3 to be an E46 racecar!
more
|
Read about how installing Giac Stage 1 DME and Borla Exhaust on a BMW 335i can greatly improve power!
more
|
|
|