1994 Chevrolet S10 Recalls
Base Regular Cab Pickup
1994 Chevrolet S10 Recall Record
Recall ID # 99I006000 - SERVICE BRAKES, HYDRAULIC:ANTILOCK
Recall Date:
JUL 19, 1999
Component:
SERVICE BRAKES, HYDRAULIC:ANTILOCK
Description
THIS IS NOT A SAFETY RECALL IN ACCORDANCE WITH THE SAFETY ACT. HOWEVER, IT IS DEEMED A SAFETY IMPROVEMENT CAMPAIGN BY THE AGENCY. VEHICLE DESCRIPTION: CERTAIN LIGHT DUTY PICKUP TRUCKS, SPORT UTILITY VEHICLES, OR MINIVANS EQUIPPED WITH 3-SENSOR ABS (ANTILOCK BRAKING SYSTEM) EBC4 UNITS.
Consequence
THESE VEHICLES CAN EXPERIENCE EXTENDED STOPPING DISTANCES DURING ABS STOPS ON CERTAIN MULTIPLE SURFACES, INCREASING THE RISK OF A CRASH.
Remedy
DEALERS WILL MODIFY THE COMPUTER PROGRAM WHICH OPERATES THE ABS UNIT ON SOME VEHICLES, OR REPLACE THE COMPUTER ON OTHERS TO IMPROVE THE PERFORMANCE OF THE ABS ON THESE SURFACES.
Manufacturer
GENERAL MOTORS CORP.
Recall ID # 99V193000 - SERVICE BRAKES, HYDRAULIC:ANTILOCK
Recall Date:
JUL 19, 1999
Component:
SERVICE BRAKES, HYDRAULIC:ANTILOCK
Description
VEHICLE DESCRIPTION: CERTAIN 4-WHEEL DRIVE PICKUP TRUCKS AND SPORT UTILITY VEHICLES EQUIPPED WITH ABS (ANTILOCK BRAKING SYSTEM) MANUFACTURED FROM SEPTEMBER 1989 THROUGH AUGUST 1996. UNDER CERTAIN DRIVING CONDITIONS THE SWITCH WHICH SIGNALS THE ABS SYSTEM WHETHER THE VEHICLE IS IN 2-WHEEL OR 4-WHEEL DRIVE CAN MALFUNCTION CAUSING INCREASED STOPPING DISTANCES DURING ABS STOPS WHILE IN THE TWO-WHEEL DRIVE MODE.
Consequence
IF THIS OCCURRED AT A TIME WHEN MINIMUM STOPPING DISTANCE WAS REQUIRED, A VEHICLE CRASH COULD OCCUR WITHOUT PRIOR WARNING.
Remedy
DEALERS WILL REPLACE OR REPAIR THE 4-WHEEL/2-WHEEL DRIVE SWITCH.
Manufacturer
GENERAL MOTORS CORP. 99041
Recall ID # 96V195000 - STEERING:GEAR BOX:SHAFT SECTOR
Recall Date:
OCT 08, 1996
Component:
STEERING:GEAR BOX:SHAFT SECTOR
Description
THE INTERMEDIATE STEERING SHAFT LOOSENS AT THE STEERING SHAFT TO STEERING GEAR COUPLING. WITH THIS LOOSENESS, THE YOKE PINCH BOLT CAN WEAR ON THE SPLINES OF THE SHAFT UNTIL THERE IS NO LONGER AN INTERFERENCE BETWEEN THE SPLINES AND THE BOLT.
Consequence
THIS CONDITION CAN CAUSE BODY TO CHASSIS MOVEMENT ALLOWING THE STEERING SHAFT TO SEPARATE FROM THE STEERING GEAR WHICH CAN RESULT IN A LOSS OF STEERING CONTROL.
Remedy
DEALERS WILL RETORQUE THE UPPER AND LOWER BOLTS TO CORRECT SPECIFICATIONS.
Manufacturer
GENERAL MOTORS CORP.
Recall ID # 97V096001 - SEAT BELTS
Recall Date:
JUN 12, 1997
Description
VEHICLE DESCRIPTION: EXTENDED CAB PICKUP TRUCKS EQUIPPED WITH 60/40 FRONT BENCH SEATS AND EXTENDED CAB PICKUP TRUCKS AND 2-DOOR UTILITY VEHICLES EQUIPPED WITH MANUAL LOCKING RECLINER BUCKET SEATS. THE OUTBOARD SAFETY BELT WEBBING ON THE DRIVER'S AND/OR PASSENGER'S SEAT CAN SEPARATE DURING A FRONTAL IMPACT.
Consequence
IF A SEPARATION OCCURRED AND THERE WERE SECONDARY CRASH EVENTS OR VEHICLE ROLLOVER, THERE WOULD BE NO BELT RESTRAINT OF THE OCCUPANT AND INCREASED INJURIES COULD OCCUR.
Remedy
DEALERS WILL INSTALL A PROTECTIVE COVER OVER THE RECLINER MECHANISM.
Manufacturer
GENERAL MOTORS CORP.
Recall ID # 94V228000 - SERVICE BRAKES, HYDRAULIC:POWER ASSIST:VACUUM:HOSES, LINES/PIPING, AND FITTINGS
Recall Date:
NOV 21, 1994
Component:
SERVICE BRAKES, HYDRAULIC:POWER ASSIST:VACUUM:HOSES, LINES/PIPING, AND FITTINGS
Description
A VACUUM HOSE CAN DETACH FROM THE POWER BRAKE BOOSTER CHECK VALVE AS A RESULT OF ENGINE BACKFIRE.
Consequence
THIS CAN RESULT IN INCREASED ENGINE IDLE AND LOSS OF POWER BRAKE ASSIST AFTER DEPLETION OF THE BOOSTER VACUUM RESERVE.
Remedy
DEALERS WILL INSTALL A CLAMP ON THE POWER BRAKE BOOSTER ASSIST.
Manufacturer
GENERAL MOTORS CORP.
Recall ID # 94V014000 - FUEL SYSTEM, GASOLINE:STORAGE:TANK ASSEMBLY:FILLER PIPE AND CAP
Recall Date:
JAN 26, 1994
Component:
FUEL SYSTEM, GASOLINE:STORAGE:TANK ASSEMBLY:FILLER PIPE AND CAP
Description
THE FUEL TANK FILLER PIPES WERE NOT MANUFACTURED TO SPECIFICATION WHICH CAUSED LOSS OF FUEL BETWEEN THE FUEL TANK FILLER PIPE AND THE VENT TUBE DURING A TEST. THE LOSS OF FUEL WAS IN EXCESS OF THE AMOUNT PERMITTED BY FMVSS NO. 301, "FUEL SYSTEM INTEGRITY."
Consequence
CONSEQUENCE OF NON-COMPLIANCE: IF A VEHICLE CRASH WERE TO OCCUR, IT MAY CAUSE THE JOINT BETWEEN THE FUEL TANK FILLER PIPES AND THE VENT TUBE TO CRACK. IF THE VEHICLE OVERTURNED, FUEL LEAKAGE WOULD OCCUR, WHICH COULD RESULT IN A POST-CRASH FIRE.
Remedy
DEALERS WILL REPLACE THE FUEL FILLER PIPE ON THESE VEHICLES.
Manufacturer
GENERAL MOTORS CORP.
Recall ID # 07E021000 - FUEL SYSTEM, OTHER:STORAGE:TANK ASSEMBLY:PRESSURE RELIEF DEVICES
Recall Date:
MAR 12, 2007
Component:
FUEL SYSTEM, OTHER:STORAGE:TANK ASSEMBLY:PRESSURE RELIEF DEVICES
Description
CERTAIN DELPHI FUEL PRESSURE REGULATORS, P/NOS. FP10020-11B1, FP10026-11B1, AND FP10027-11B1, SOLD AFTER JANUARY 9, 2007, AS AFTERMARKET EQUIPMENT FOR VARIOUS PASSENGER VEHICLES LISTED ABOVE. THE UNIVERSAL PRESSURE REGULATORS (UPR) WERE PRODUCED WITHOUT AN O'RING AND RETAINER.
Consequence
FUEL MAY LEAK, POSSIBLY RESULTING IN A FIRE.
Remedy
DELPHI WILL NOTIFY OWNERS AND REPLACE THE UPR FREE OF CHARGE. THE RECALL BEGAN ON APRIL 23, 2007. OWNERS CAN CONTACT DELPHI AT 877-411-8770.
Manufacturer
DELPHI
Recall ID # 09E025000 - EXTERIOR LIGHTING:HEADLIGHTS
Recall Date:
MAY 11, 2009
Component:
EXTERIOR LIGHTING:HEADLIGHTS
Description
DOPE, INC. IS RECALLING 42,540 COMBINATION CORNER AND BUMPER LAMP ASSEMBLIES OF VARIOUS PART NUMBERS SOLD FOR USE AS AFTERMARKET EQUIPMENT FOR VARIOUS PASSENGER VEHICLES. THESE HEADLAMPS FAIL TO CONFORM TO THE REQUIREMENTS OF FEDERAL MOTOR VEHICLE SAFETY STANDARD NO. 108, "LAMPS, REFLECTIVE DEVICES, AND ASSOCIATED EQUIPMENT." THESE LAMPS DO NOT CONTAIN THE REQUIRED AMBER SIDE REFLECTORS.
Consequence
DECREASED LIGHTING VISIBILITY MAY RESULT IN A VEHICLE CRASH.
Remedy
DOPE, INC. WILL NOTIFY OWNERS AND OFFER A FULL REFUND FOR THE NONCOMPLIANT COMBINATION LAMPS. THE SAFETY RECALL BEGAN ON JULY 28, 2009. OWNERS MAY CONTACT DOPE, INC. AT 1-626-272-1798.
Manufacturer
DOPE, INC.