1991 Ford Escort Recalls
Base Hatchback
1991 Ford Escort Recall Record
Recall ID # 94E019000 - SUSPENSION:FRONT
Recall Date:
JUN 02, 1994
Component:
SUSPENSION:FRONT
Description
THE OFFSET TOE ADJUSTING PIN CAN FRACTURE UNDER CONDITIONS SUCH AS TORSIONAL LOADS, FLEXING MOTION, IMPACT LOADS, AND OVERTORQUING.
Consequence
THIS CAN RESULT IN LOSS OF VEHICLE STEERING CONTROL ANDAN ACCIDENT.
Remedy
DANA WILL PAY FOR REPLACEMENT AND LABOR COSTS OF THE ADJUSTMENT PIN WITHOUT CHARGE TO THE INSTALLING FACILITY AND THE VEHICLE OWNER. THESE PINS SHOULD BE REPLACED BY A FORD ORIGINAL EQUIPMENT PIN ASSEMBLY. OWNER OR INSTALLER INQUIRIES CONCERNING THIS RECALL CAMPAIGN SHOULD CONTACT DANA SERVICE CENTER AT 1-800-248-9606.
Manufacturer
DANA CORPORATION
Recall ID # 93V057000 - ELECTRICAL SYSTEM:IGNITION:ANTI-THEFT CONTROLLER
Recall Date:
APR 15, 1993
Component:
ELECTRICAL SYSTEM:IGNITION:ANTI-THEFT CONTROLLER
Description
THE ROLL PINS SECURING THE IGNITION LOCK IN THE STEERING COLUMN HOUSING CAN SEPARATE OR MOVE OUT OF POSITION.
Consequence
THE IGNITION LOCK CYLINDER MAY DISENGAGE FROM THESTEERING COLUMN HOUSING WHICH COULD CAUSE THE STEERING COLUMN TO LOCK UP,RESULTING IN LOSS OF VEHICLE CONTROL AND A POSSIBLE ACCIDENT.
Remedy
IF ONE OR BOTH OF THE ROLL PINS ARE MISSING OR NOT FULLY INSERTED, THE IGNITION LOCK HOUSING WILL BE REPLACED, ALONG WITH THE DOOR-LOCKS AND THE LIFTGATE OR DECK-LID LOCKS SO THAT KEY COMPATIBILITY IS MAINTAINED. IF BOTH PINS ARE PRESENT AND FULLY INSERTED, A PLASTIC SNAP-ON SLEEVE WILL BE INSTALLED AS A PRECAUTION TO PREVENT THE ROLL PINS FROM COMING OUT.
Manufacturer
FORD MOTOR COMPANY
Recall ID # 90V076000 - VEHICLE SPEED CONTROL:ACCELERATOR PEDAL
Recall Date:
APR 17, 1990
Component:
VEHICLE SPEED CONTROL:ACCELERATOR PEDAL
Description
INTERFERENCE OCCUR BETWEEN BOLT THAT SECURES A FUEL LINE SHIELD TO THE LOWER PORTION OF THE DASH PANEL AND THE ACCELERATOR PEDAL.
Consequence
THIS COULD CAUSE THE ACCELERATOR PEDAL TO STICK AT THE WIDE OPEN THROTTLE POSITION AND RESULT IN LOSS OF CONTROL WITH THE RISK OF A VEHICLE ACCIDENT.
Remedy
CUT OFF EXTRA LENGTH OF BOLT THAT PROTRUDES ABOVE SURFACE OF WELD NUT TO PREVENT INTERFERENCE.
Manufacturer
FORD MOTOR COMPANY
Recall ID # 92V117000 - FUEL SYSTEM, GASOLINE
Recall Date:
AUG 19, 1992
Component:
FUEL SYSTEM, GASOLINE
Description
FATIGUE CRACKS CAN DEVELOP IN THE SOLDER JOINT BETWEEN THE FUEL RETURN TUBE AND THE FUEL PUMP SENDING UNIT LOCATED AT THE TOP OF THE FUEL TANK.
Consequence
SHOULD A CRACK DEVELOP, FUEL VAPOR CAN ESCAPE FROM THETANK WHEN THE TANK IS FULL, AND A SMALL AMOUNT OF FUEL CAN LEAK FROM THE CRACK.FUEL LEAKS CAN RESULT IN FIRE WHEN EXPOSED TO A SOURCE OF IGNITION.
Remedy
INSTALL A NEW FUEL PUMP SENDING ASSEMBLY.
Manufacturer
FORD MOTOR COMPANY